![]() ![]() Pour the water up to the top of the condensate pump until the float activates. Test the pump by pouring in water into one of the extra inlet holes on the top of the pump. Step 8 - Test The Condensate Pump By Pouring In Water If there is no plug, you will have to hardwire the pump to the furnace. It is usually a standard 3-pronged plug to a standard 120-volt outlet-GFCI protected. Plug in the condensate pump into an outlet. Without this safety precaution, an overflowing condensate pump can cause significant structural damage to the home.) Step 7 - Plug In Condensate Pump (An update to the International Plumbing Code requires a safety switch to be connected if the condensate pump is located in an unfinished space such as an attic or crawlspace. You can also connect these wires to a water alarm instead. This will turn off the furnace or A/C automatically if the condensate pump fails or overflows. If the condensate pump has extra wiring for a safety switch, then you must connect these wires in series with the low voltage thermostat circuit. Step 6 - Connect Safety Switch Or AlarmĬonnect the safety switch or alarm so that it will shut off the HVAC if there is a drainage problem. Most lids on condensate pumps can be reversed if you want the discharge tubing on the other side of the pump. The horizontal portion of the discharge tubing needs to be sloped downwards to help draining. Homeowners should first install the vinyl tubing vertically to the required height, and then horizontally. Secure the discharge tubing so it won't move and make sure there is the proper slope. Step 5 - Secure Discharge Tubing And Make Sure It Slopes ![]() You want to make sure that the pump is flat and that it is below the condensate drain pan. Secure the condensate pump to the furnace, wall, or to the floor.Įven though many condensate pumps are loosely laid on the floor, they are supposed to be secured to either the air handler or to a wall.Ĭondensate pumps have two slots on the side that are used to screw the unit to the furnace or wall. Step 2 - Secure The Condensate Pump So It Won't Move ![]() This insert will have to be removed prior to operation. Unpack the condensate pump and remove the cardboard insert that secures the float switch during shipping. Step 1 - Unpack The Condensate Pump And Remove Insert
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |